D-Link DGS-3130 Emulator - Page 648

Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide access-group name ACCESS-LIST-NAME cos [inner] COS-LIST [ip] dscp DSCP-LIST [ip] precedence IPPRECEDENCE-LIST protocol PROTOCOLNAME vlan [inner] VLAN-LIST Specifies an access list to be matched. Traffic that is permitted by the access list will be classified. Specifies a specific IEEE 802.1Q CoS value(s) to be matched. The COS-LIST parameter values are from 0 to 7. Enter one or more CoS values separated by commas or hyphen for a range list. inner - (Optional) Specifies to match the inner most CoS of QinQ packets on a Layer 2 class of service (CoS) marking. Specifies differentiated service code point values to be matched. Enter one or more differentiated service code point (DSCP) values separated by commas or hyphen for a range list. The valid range is from 0 to 63. ip - (Optional) Specifies that the match is for IPv4 packets only. If not specified, the match is for both IPv4 and IPv6 packets. Specifies IP precedence values to be matched. Enter one or more precedence values separated by commas or hyphen for a range list. The valid range is from 0 to 7. ip - (Optional) Specifies that the match is for IPv4 packets only. If not specified, the match is for both IP and IPv6 packets. For IPv6 packets, the precedence is most three significant bits of traffic class of IPv6 header. Specifies the protocol name to be matched. Specifies the VLAN identification number, numbers, or range of numbers to be matched. Valid VLAN identification numbers must be in the range of 1 to 4094. Enter one or more VLAN values separated by commas or hyphens for a range list. inner - (Optional) Specifies to match the inner-most VLAN ID in an 802.1Q double tagged frame. Default None. Command Mode Class-map Configuration Mode. Command Default Level Level: 12. Usage Guideline To use the match command, first enter the class-map command to specify the name of the class that will be used to establish the match criteria. The policy for handling these matched packets is defined in the policy-map class configuration mode. The following lists the reference for the supported protocols for the match protocol command.  arp - IP Address Resolution Protocol (ARP).  bgp - Border Gateway Protocol.  dhcp - Dynamic Host Configuration.  dns - Domain Name Server lookup.  egp - Exterior Gateway Protocol.  ftp - File Transfer Protocol.  ip - IP (version 4).  ipv6 - IP (version 6).  netbios - NetBIOS.  nfs - Network File System. 644