D-Link DGS-3130 Emulator - Page 474
IPv6 Snooping Commands
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 474 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 43. IPv6 Snooping Commands 43-1 ipv6 snooping policy This command is used to create or modify an IPv6 snooping policy. This command will enter the IPv6 snooping configuration mode. Use the no form of this command to delete an IPv6 snooping policy. ipv6 snooping policy POLICY-NAME no ipv6 snooping policy POLICY-NAME Parameters POLICY-NAME Specifies the name of the snooping policy. Default No IPv6 snooping policy is created. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to create an IPv6 snooping policy. After an IPv6 snooping policy has been created, use the ipv6 snooping attach-policy command to apply the policy on a specific interface. Example This example shows how to create an IPv6 snooping policy named policy1. Switch# configure terminal Switch(config)#ipv6 snooping policy policy1 Switch(config-ipv6-snooping)# 43-2 protocol This command is used to specify the protocol that IPv6 snooping should be enabled for. Use the no form of this command to disable snooping for the specific protocol. protocol {dhcp | ndp | dhcp-pd} no protocol {dhcp | ndp | dhcp-pd} Parameters dhcp ndp dhcp-pd Specifies that addresses should be snooped in DHCPv6 packets. Specifies that addresses should be snooped in NDP packets. Specified that IPv6 prefix should be snooped in DHCPv6 PD packets. 470