D-Link DGS-3130 Emulator - Page 702
Routing Information Protocol RIP, Commands
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 702 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 68. Routing Information Protocol (RIP) Commands 68-1 address-family (RIP) This command is used to enter the Router Address Family Configuration (RIP) mode to configure the setting specific to the address family. Use the no form of this command to remove the specified address family. address-family ipv4 no address-family ipv4 Parameters None. Default None. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to enter the Router Address Family Configuration (RIP) mode to configure the setting specific to the address family. Example This example shows how to enter the Router Address Family Configuration (RIP) mode. Switch#configure terminal Switch(config)#router rip Switch(config-router)#address-family ipv4 Switch(config-router-af)# 68-2 default-metric (RIP) This command is used to configure the value to be used as the default metric for routes redistributed to RIP. Use the no form of this command to revert to the default setting. default-metric METRIC-VALUE no default-metric Parameters METRIC-VALUE Specifies the default metric value. The valid range of values is from 0 to 16. 698