D-Link DGS-3130 Emulator - Page 389

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline When the Switch learns or removes a MAC address, a notification can be sent to the notification history table and then sent to the SNMP server if the snmp-server enable traps mac-notification change command is enabled. The MAC notification history table stores the MAC address learned or deleted on each interface for which the trap is enabled. Events are not generated for multicast addresses. Example This example shows how to enable MAC address change notification and set the interval to 10 seconds and set the history size value to 500 entries. Switch# configure terminal Switch(config)# mac-address-table notification change Switch(config)# mac-address-table notification change interval 10 Switch(config)# mac-address-table notification change history-size 500 Switch(config)# 35-6 mac-address-table static This command is used to add a static address to the MAC address table. Use the no form of the command to remove a static MAC address entry from the table. mac-address-table static MAC-ADDR vlan VLAN-ID {interface INTERFACE-ID [, | -] | drop} no mac-address-table static {all | MAC-ADDR vlan VLAN-ID [interface INTERFACE-ID] [, | -]} Parameters MAC-ADDR vlan VLAN-ID interface INTERFACE-ID , drop all Specifies the MAC address of the entry. The address can be a unicast or a multicast entry. Packets with a destination address that match this MAC address received by the specified VLAN are forwarded to the specified interface. Specifies the VLAN of the entry. The range is 1 to 4094. Specifies the forwarding ports. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Specifies to drop the frames that are sent by or sent to the specified MAC address on the specified VLAN. Specifies to remove all static MAC address entries. Default No static addresses are configured. Command Mode Global Configuration Mode. 385