D-Link DGS-3130 Emulator - Page 595

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to specify ethernet 1/0/1 to operate in the mac-wac mode. Switch#configure terminal Switch(config)#interface ethernet 1/0/1 Switch(config-if)#authentication compauth mode mac-wac Switch(config-if)# 55-11 authentication max users This command is used to configure the maximum authenticated users for the entire system or for a port. Use the no form of this command to revert to the default setting. authentication max users NUMBER no authentication max users Parameters NUMBER Specifies to set the maximum authenticated users' number. The range is from 1 to 4096. Default By default, there is no limit. Command Mode Global Configuration Mode. Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command can be used in the global configuration mode and interface configuration mode. If the command is configured in the global configuration mode, the maximum user number limits the user number of the entire system. If the command is configured in the interface configuration mode, the maximum user number is set for the interface. The maximum users being limited include 802.1X, MAC-based Access Control, and WAC users. In addition, the command has the following limitation:  If the new maximum is less than the current number of users, the command will be rejected and the error message will be prompted. Example This example shows how to set the maximum authenticated users for system. Switch# configure terminal Switch(config)# authentication max users 256 Switch(config)# 591