D-Link DGS-3130 Emulator - Page 337

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch#show errdisable recovery ErrDisable Cause Port Security Storm Control BPDU Attack Protection Dynamic ARP Inspection DHCP Snooping Loop Detection l2pt-guard D-LINK Unidirectional Link Detection State ----------disabled disabled disabled disabled disabled disabled disabled disabled Interval 300 seconds 300 seconds 300 seconds 300 seconds 300 seconds 300 seconds 300 seconds 300 seconds Interfaces that will be recovered at the next timeout: Interface --------eth1/0/7 eth2/0/3 eth2/0/5 Errdisable Cause BPDU Attack Protection Loop Detection Loop Detection Time left(sec infinite 45 45 Switch# 31-3 snmp-server enable traps transceiver-monitoring This command is used to enable the sending of SNMP notifications for the error disabled state. Use the no form of this command to disable the sending of SNMP notifications. snmp-server enable traps errdisable [asserted] [cleared] [notification-rate TRAP-RATE] no snmp-server enable traps errdisable [asserted] [cleared] [notification-rate] Parameters asserted cleared notification-rate (Optional) Specifies to enable or disable the sending of SNMP notifications for entering the error disabled state. (Optional) Specifies to enable or disable the sending of SNMP notifications for exiting the error disabled state. (Optional) Specifies the number of traps per minute. The value is from 0 to 1000. If the number of packets exceeds the specified number, the exceeded packets will be dropped. 0 represents that there is no limitation for the sending of the SNMP traps for the error disabled state per minute. Default By default, this feature is disabled. By default, the notification rate is 0. Command Mode Global Configuration Mode. Command Default Level Level: 12. 333