D-Link DGS-3130 Emulator - Page 373

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 33-18 timer This command is used to configure timers for an ERPS profile. Use the no form of this command to revert to the default setting. timer {guard MILLI-SECONDS | hold-off SECONDS | wtr MINUTES} no timer [guard | hold-off | wtr] Parameters guard MILLI-SECONDS hold-off SECONDS wtr MINUTES Specifies the guard timer in milliseconds. The valid range is from 10 to 2000. The value should be multiples of 10. Specifies the hold-off timer in seconds. The valid range is from 0 to 10. Specifies the WTR timer in minutes. The valid range is from 1 to 12. Default The default guard timer is 500 milliseconds. The default hold-off timer is 0. The default WTR timer is 5 minutes. Command Mode G.8032 Profile Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the timers to be used by ERPS instances associated with the profile. Use the no form of this command to revert to the default setting. If no parameter is specified in the no form of this command, all timers will be reset. Example This example shows how to configure the guard timer to 700 milliseconds, hold-off timer to 1 second, and WTR timer to 1 minute for profile "campus". Switch#configure terminal Switch(config)#ethernet ring g8032 profile campus Switch(config-erps-ring-profile)#timer guard 700 Switch(config-erps-ring-profile)#timer hold-off 1 Switch(config-erps-ring-profile)#timer wtr 1 Switch(config-erps-ring-profile)# 33-19 ring_id This command is used to specify the ring ID of a physical ring. Use the no form of this command to remove the configuration. ring_id RING_ID no ring_id 369