D-Link DGS-3130 Emulator - Page 579
show mvlan group-profile
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 579 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide IPV6-ADDRESS-START IPV6-ADDRESS-END Specifies the IPv6 multicast start address in the range. Specifies the IPv6 multicast end address in the range. Default None. Command Mode Multicast VLAN Profile Configuration Mode. Command Default Level Level: 12. Usage Guideline Multiple ranges can be added to a multicast VLAN profile. The IP address ranges specified in a single profile must be in the same address family. Example This example shows how to add an IPv4 range into the profile called "profile mv_profile1". Switch#configure terminal Switch(config)#mvlan group-profile mv_profile1 Switch(config-mvlan-profile)#range 225.0.0.0 225.0.0.5 Switch(config-mvlan-profile)# 53-10 show mvlan group-profile This command is used to display the multicast group profile configuration. show mvlan group-profile [PROFILE-NAME] Parameters PROFILE-NAME (Optional) Specifies the profile name. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline Use this command to display all group profiles by not specifying the profile name. 575
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/579.png)