D-Link DGS-3130 Emulator - Page 208
default-router
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
Parameters IDENTIFIER DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies a DHCP client identifier in hexadecimal notation. Default None. Command Mode DHCP Pool Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is valid for manual binding entries in a DHCP address pool. The client identifier is formatted by media type and the MAC address. Only one manual binding entry can be specified in a DHCP address pool. With a manual binding entry, the IP address can be either be bound with a client-identifier or bound with the hardware address of the host. Use the client-identifier command and the host command to specify the manual binding entry based on the client-identifier in the DHCP packet. Example This example shows how a DHCP address pool "pool1" is created with a manual binding entry which binds the IP address 10.1.2.3/24 with client ID 0x01524153203124. Switch# configure terminal Switch(config)# ip dhcp pool pool1 Switch(config-dhcp-pool)# client-identifier 01524153203124 Switch(config-dhcp-pool)# host 10.1.2.3/24 Switch(config-dhcp-pool)# 19-8 default-router This command is used to specify default routers for the DHCP client. Use the no form of this command to remove the default router. default-router IP-ADDRESS [IP-ADDRESS2...IP-ADDRESS8] no default-router IP-ADDRESS [IP-ADDRESS2...IP-ADDRESS8] Parameters IP-ADDRESS IP-ADDRESS2...IPADDRESS8 Specifies the IP address of the default router for the DHCP client. Specifies multiple IP addresses, separated by spaces. Up to eight addresses can be specified. Default None. 204
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/208.png)