D-Link DGS-3130 Emulator - Page 137
ipv6 nd managed-config-flag
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Parameters BYTES DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies to set the IPv6 MTU value. The range is 1280 to 65534 bytes. Default By default, the IPv6 MTU value is 1500 bytes. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is available for Layer 3 capable interface configuration. Use this command to configure the MTU to be advertised in RA messages. The IPv6 packet originated at the system will be transmitted based on this value. The check is done in the egress direction. Oversized packets will be sent to the supervisor blade for further processing. Example This example shows how to set the IPv6 MTU value as 6000 bytes at VLAN 4. Switch# configure terminal Switch(config)# interface vlan 4 Switch(config-if) ipv6 mtu 6000 Switch(config-if)# exit Switch(config)# This example shows how to restore the default IPv6 MTU value. Switch# configure terminal Switch(config)# interface vlan 4 Switch(config-if)# no ipv6 mtu Switch(config-if)# 10-9 ipv6 nd managed-config-flag This command is used to turn on the management configuration flag in the advertised RA message. Use the no form of this command to turn off the flag. ipv6 nd managed-config-flag no ipv6 nd managed-config-flag Parameters None. Default By default, this feature is disabled. 133