D-Link DGS-3130 Emulator - Page 84

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline This command displays information about the active lines on the Switch. Example This example shows how to display all session information. Switch# show users ID Type User-Name Privilege Login-Time IP address 0 * console admin 15 12M5S 1 telnet monitoruser 2 3DT2H20M15S 172.171.160.100 10 SSH 123 15 1M45S 172.171.160.100 Total Entries: 3 Switch# 5-20 telnet This command is used to login another device that supports Telnet. telnet [IP-ADDRESS | IPV6-ADDRESS] [TCP-PORT] Parameters IP-ADDRESS IPV6-ADDRESS TCP-PORT Specifies the IPv4 address of the host. Specifies the IPv6 address of the host. Specifies the TCP port number. TCP ports are numbered between 1 and 65535. The "well-known" TCP port for the Telnet protocol is 23 Default None. Command Mode User/Privileged EXEC Mode. Command Default Level Level: 1. Usage Guideline This is the Telnet client function and can be used to communicate with another device using the Telnet feature. The Telnet software supports special Telnet commands in the form of Telnet sequences that map generic terminal control functions to operating system-specific functions. To issue a special Telnet command, enter the escape sequence and then a command character. The default escape sequence is CTRL+_ (press and hold the CTRL and Shift keys and the underscore '_' key). The special Telnet commands will be displayed as follows:  e - Exits the Telnet connection. Either an uppercase or lowercase letter 'e' can exit the Telnet connection. If another key is pressed, the terminal will return to the original active Telnet session. Multiple Telnet sessions can be opened on the Switch system and each open Telnet session can have its own Telnet client software supported at the same time 80