D-Link DGS-3130 Emulator - Page 567

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline Use this command to display MLD snooping limit and access group information. If no optional parameter is specified, MLD snooping filter information for all interfaces will be displayed. Example This example shows how to display filter information when no interface is specified. Switch# show ipv6 mld snooping filter eth1/0/1: Rate limit: 30pps Access group: mld_filter Groups/Channel Limit: Not Configured vlan 1: Access group: Not Configured Groups/Channel Limit: 25 (Exception List: mld_filter, exceed-action: drop) eth1/0/3: Rate limit: 20pps Access group: mld_filter Groups/Channel Limit: Not Configured vlan 1: Access group: mld_filter Groups/Channel Limit: Not Configured vlan 2: Access group: Not Configured Groups/Channel Limit: 100 (exceed-action: replace) port-channel4: Rate limit: 200pps Access group: Not Configured Groups/Channel Limit: Not Configured Switch# 52-22 show ipv6 mld snooping groups This command is used to display MLD snooping group information learned on the Switch. show ipv6 mld snooping groups [IPV6-ADDRESS | vlan VLAN-ID] [detail] Parameters IPV6-ADDRESS vlan VLAN-ID , detail (Optional) Specifies the group IP address. If no IPv6 address is specified, all MLD group information will be displayed. (Optional) Specifies the VLAN ID to be displayed. If no VLAN is specified, MLD group information about all VLANs will be displayed. (Optional) Specifies a series of VLANs, or separate a range of interfaces from a previous range. No space is allowed before and after the comma. (Optional) Specifies a range of VLANs. No space is allowed before and after the hyphen. (Optional) Specifies to display the MLD group detail information. 563