D-Link DGS-3130 Emulator - Page 532
loopback-detection vlan
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 532 highlights
Parameters SECONDS DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies the interval in seconds at which LBD packets are transmitted. The valid range is from 1 to 32767. Default By default, this value is 10 seconds. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the interval at which LBD packets are sent to discover the loop occurrence. Example This example shows how to configure the time interval to 20 seconds. Switch# configure terminal Switch(config)# loopback-detection interval 20 Switch(config)# 49-4 loopback-detection vlan This command is used to configure the VLANs to be enabled for loop detection. Use the no form of this command to revert to the default setting. loopback-detection vlan VLAN-LIST no loopback-detection vlan VLAN-LIST Parameters VLAN-LIST Specifies the VLAN identification number, numbers, or range of numbers to be matched. Enter one or more VLAN values separated by commas or hyphens for a range list. Default By default, this option is enabled for all VLANs. Command Mode Global Configuration Mode. Command Default Level Level: 12. 528