D-Link DGS-3130 Emulator - Page 507

Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide IP-ADDRESS IPV6-ADDRESS (Optional) Specifies the IPv4 address that is carried in the management address TLV. (Optional) Specifies the IPv6 address that is carried in the management address TLV. Default No LLDP management address is configured (no Management Address TLV is sent). Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is available for physical port configuration. This command specifies the IPv4/IPv6 address that is carried in the management address TLV on the specified port. If an IP address is specified, but the address is not associated with one of the interfaces on the system, then the address will not be sent. When no address is specified using the lldp management-address command, the Switch will find at least one IPv4 and IPv6 address in the VLAN with the lowest VLAN ID. If no applicable IPv4/IPv6 address exists, then no management address TLV will be advertised. Once the administrator configures an address, both of the default IPv4 and IPv6 management address will become inactive and will not be sent. The default IPv4 or IPv6 address will be active again when all the configured addresses are removed. Multiple IPv4/IPv6 management addresses can be configured by using this command multiple times. Use the no lldp management-address command without a management address to disable the management address adverted in LLDPDUs. If there is no effective management address in the list, no management address TLV will be sent. Example This example shows how to enable ethernet 1/0/1 and 1/0/2 for setting the management address entry (IPv4). Switch# configure terminal Switch(config)# interface range ethernet 1/0/1-1/0/2 Switch(config-if-range)# lldp management-address 10.1.1.1 Switch(config-if-range)# This example shows how to enable ethernet 1/0/3 and 1/0/4 for setting the management address entry (IPv6). Switch# configure terminal Switch(config)# interface range ethernet 1/0/3-1/0/4 Switch(config-if-range)# lldp management-address FE80::250:A2FF:FEBF:A056 Switch(config-if-range)# This example shows how to delete the management address 10.1.1.1 from ethernet 1/0/1 and 1/0/2. If 10.1.1.1 is the last one, no management address TLV will be sent. Switch# configure terminal Switch(config)# interface range ethernet 1/0/1-1/0/2 Switch(config-if-range)# no lldp management-address 10.1.1.1 Switch(config-if-range)# 503