D-Link DGS-3130 Emulator - Page 162
debug copy, debug clear buffer
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch#configure terminal Switch(config)#debug reboot on-error Switch(config)# 15-4 debug copy This command is used to copy debug information to the destination filename. debug copy SOURCE-URL DESTINATION-URL debug copy SOURCE-URL {tftp: //LOCATION/DESTINATION-URL} Parameters SOURCE-URL LOCATION Specifies the source URL for the source file to be copied. It must be one of the following keywords. buffer: Specifies to copy the debug buffer information. error-log: Specifies to copy the error log information. tech-support: Specifies to copy the technical support information. Specifies the IPv4 or IPv6 address of the TFTP server. Default None. Command Mode Privileged EXEC Mode. Command Default Level Level: 15. Usage Guideline Use this command to copy debug information to the destination filename. Example This example shows how to copy debug buffer information to a TFTP server (10.90.90.99). Switch# debug copy buffer tftp: //10.90.90.99/abc.txt Address of remote host [10.90.90.99]? Destination filename [abc.txt]? Accessing tftp://10.90.90.99/abc.txt... Transmission starts... Finished network upload(65739) bytes. Switch# 15-5 debug clear buffer This command is used to clear the debug buffer. 158
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/162.png)