D-Link DGS-3130 Emulator - Page 913

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 92. Voice VLAN Commands 92-1 voice vlan This command is used to enable the global voice VLAN state and configure the voice VLAN. Use the no form of this command to disable the voice VLAN state. voice vlan VLAN-ID no voice vlan Parameters VLAN-ID Specifies the ID of the voice VLAN. The valid range is from 2 to 4094. Default By default, this option is disabled. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to enable the global voice VLAN function and to specify the voice VLAN on the Switch. The Switch has only one voice VLAN. Both the voice vlan command in the global configuration and the voice vlan enable command in the interface configuration mode need to be enabled for a port to start the voice VLAN function. When the voice VLAN is enabled for a port, the received voice packets will be forwarded in the voice VLAN. The received packets are determined as voice packets if the source MAC addresses of packets comply with the organizationally unique identifier (OUI) addresses configured by the voice vlan mac-address command. The VLAN to be specified as the voice VLAN needs to pre-exist before configuration. If the voice VLAN is configured, the voice VLAN cannot be removed with the no vlan command. Example This example shows how to enable the voice VLAN function and configure VLAN 1000 as the voice VLAN. Switch# configure terminal Switch(config)# voice vlan 1000 Switch(config)# 92-2 voice vlan aging This command is used to configure the aging time for aging out the voice VLAN's dynamic member ports. Use the no form of this command to revert to the default setting. voice vlan aging MINUTES no voice vlan aging 909