D-Link DGS-3130 Emulator - Page 49

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 4-7 ipv6 access-group This command is used to specify the IPv6 access list to be applied to an interface. Use the no form of this command to remove an IPv6 access list. ipv6 access-group {NAME} [in | out] no ipv6 access-group [NAME] [in | out] Parameters NAME in out Specifies the name of the IPv6 access list to be applied. (Optional) Specifies that the IPv6 access list will be applied to check in the ingress direction. If the direction is not specified, in is used. (Optional) Specifies that the IPv6 access list will be applied to check in the egress direction. Default None. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Only one access list of the same type can be applied to the same interface, but access lists of different types can be applied to the same interface. The association of an access group with an interface will consume the filtering entry resource in the switch controller. If the resource is insufficient to commit the command, then an error message will be displayed. There is a limitation on the number of port operator resources. If applying the command exhausts the available port selectors, then an error message will be displayed. Example This example shows how to specify the IPv6 access list "ip6-control" as an IP access group for ethernet 1/0/3. Switch#configure terminal Switch(config)#interface ethernet 1/0/3 Switch(config-if)#ipv6 access-group ip6-control in The remaining applicable IPv6 related access entries are 448, remaining range entries are 32. Switch(config-if)# 4-8 ipv6 access-list This command is used to create or modify an IPv6 access list. This command will enter into IPv6 access-list configuration mode. Use the no form of this command to remove an IPv6 access list. ipv6 access-list [extended] NAME no ipv6 access-list [extended] {NAME} 45