D-Link DGS-3130 Emulator - Page 721
show ipv6 rip
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 721 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default By default, routing updates are sent. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline If this option is disabled, the router will not send RIPng packet out through the interface. However, RIPng packets from other routers received on the interface will continue to be processed. Example This example shows how to disable the sending of the routing updates on an interface. Switch#configure terminal Switch(config)#ipv6 router rip Switch(config-rtr)#passive-interface vlan 1 Switch(config-rtr)# 69-10 show ipv6 rip This command is used to display interface information of RIPng. show ipv6 rip [database] Parameters database (Optional) Specifies to display the entry in the RIP routing database. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline Use this command to display the configuration information of RIP protocol. Use the show ipv6 rip database command to display the entry in the RIP routing database. Example This example shows how to display the RIP configuration information. 717
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/721.png)