D-Link DGS-3130 Emulator - Page 51

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide out (Optional) Specifies that the MAC access list will be applied to check in the egress direction. Default None. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline If MAC access group is already configured on the interface, the command applied later will overwrite the previous setting. MAC access-groups will only check non-IP packets. Only one access list of the same type can be applied to the same interface, but access lists of different types can be applied to the same interface. The association of an access group with an interface will consume the filtering entry resource in the switch controller. If the resource is insufficient to commit the command, then an error message will be displayed. Example This example shows how to apply the MAC access list daily-profile to ethernet 1/0/4. Switch#configure terminal Switch(config)#interface ethernet 1/0/4 Switch(config-if)#mac access-group daily-profile in The remaining applicable MAC access entries are 896, remaining range entries are 32. Switch(config-if)# 4-10 mac access-list This command is used to create or modify an MAC access list and this command will enter the MAC access list configuration mode. Use the no form of this command to delete a MAC access list. mac access-list extended NAME no mac access-list extended {NAME} Parameters NAME Specifies the name of the MAC access list to be configured. The maximum length is 32 characters. Default None. Command Mode Global Configuration Mode. 47