D-Link DGS-3130 Emulator - Page 708

Default None. DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode Router Configuration Mode. Router Address Family Configuration (RIP) Mode. Command Default Level Level: 12. Usage Guideline Use this command to specify networks in which routing updates will be sent and received. The interface that has a subnet defined belonging to a network specified by this command will be activated with RIP. Example This example shows how to define RIP as the routing protocol to be used on all interfaces connected to networks 192.168.70.0/24 and network 10.99.0.0/16. Switch# configure terminal Switch(config)# router rip Switch(config-router)# network 192.168.70.0 Switch(config-router)# network 10.99.0.0 Switch(config-router)# 68-10 passive-interface This command is used to disable the sending of routing updates on an interface. Use the no form of this command to revert to the default setting. passive-interface {default | INTERFACR-ID} no passive-interface {default | INTERFACR-ID} Parameters default INTERFACR-ID Specifies the global default passive state for all interfaces. Specifies the interface identifier for setting the passive state. If passive state of an interface is not specified, it follows the global default passive state. Default By default, routing updates are sent. Command Mode Router Configuration Mode. Router Address Family Configuration (RIP) Mode. Command Default Level Level: 12. 704