D-Link DGS-3130 Emulator - Page 447
ip igmp snooping suppression-time, ip igmp snooping minimum-version
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 447 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 39-20 ip igmp snooping suppression-time This command is used to configure the time for suppressing duplicate IGMP reports or leaves. Use the no form of this command to revert to the default setting. ip igmp snooping suppression-time SECONDS no ip igmp snooping suppression-time Parameters SECONDS Specifies to configure the time for suppressing duplicates IGMP reports. The range is from 1 to 300. Default By default, this value is 10 seconds. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is only available for VLAN interface configuration. The report suppression function will suppress the duplicate IGMP report or leave packets received in the suppression time. A small suppression time will cause the duplicate IGMP packets be sent more frequently. Example This example shows how to configure the suppression time to be 125 on VLAN 1000. Switch# configure terminal Switch(config)# vlan 1000 Switch(config-vlan)# ip igmp snooping suppression-time 125 Switch(config-vlan)# 39-21 ip igmp snooping minimum-version This command is used to configure the minimum version of IGMP hosts that is allowed on the interface. Use the no form of this command to remove the restriction from the interface. ip igmp snooping minimum-version {2 | 3} no ip igmp snooping minimum-version Parameters 2 3 Specifies to filter out IGMPv1 messages. Specifies to filter out IGMPv1 and IGMPv2 messages. Default By default, there is no limit on the minimum version. 443