D-Link DGS-3130 Emulator - Page 509
lldp receive, 10 lldp reinit
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 509 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# lldp med-tlv-select capabilities Switch(config-if)# 48-9 lldp receive This command is used to enable a physical interface to receive LLDP messages. Use the no form of this command to disable receiving LLDP messages. lldp receive no lldp receive Parameters None. Default LLDP is enabled on all supported interfaces. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is available for physical port configuration. This command is used to enable a physical interface to receive LLDP messages. When LLDP is not running, the Switch does not receive LLDP messages. Example This example shows how to enable a physical interface to receive LLDP messages. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# lldp receive Switch(config-if)# 48-10 lldp reinit This command is used to configure the minimum re-initialization the delay on the Switch. Use the no form of this command to revert to the default setting. lldp reinit SECONDS no lldp reinit Parameters SECONDS Specifies the delay value for LLDP initialization on an interface. This value must be between 1 and 10 seconds. 505