D-Link DGS-3130 Emulator - Page 606

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline There are counters on port to record the statistic and they can be shown by show poe power-inline statistics command. Use this command to clear all the counter value on the port. Example This example shows how to clear statistic on interface eth3/0/1. Switch# clear poe statistic interface eth3/0/1 56-9 show poe power-inline This command is used to display the Power over Ethernet (PoE) status for the specified PoE port, or for all PoE ports in the switch system. show poe power-inline [INTERFACE-ID [, | -] ] {status | configuration | statistics | measurement | lldpclassification } Parameters INTERFACE-ID , status configuration statistics measurement lldp-classification (Optional) Specify the interface to be displayed. (Optional) Specify a series of interfaces, or separate a range of interfaces from a previous range. No space before and after the comma. (Optional) Specify a range of interfaces. No space before and after the hyphen. Display the port PoE status Display the port configuration information Display the port error counters Display the port voltage, current, consumed power and temperature Display the data link layer classification using information of power via MDI TLV. Default None. Command Mode EXEC mode or any configuration mode. Command Default Level Level: 1. Usage Guideline The show poe power-inline command is used to display the PoE status of port, power inline configuration status, statistic counters, the measurement result and the data link layer classification using information. If INTERFACE-ID is not specified with this command, then all PoE interfaces will be shown. Only the PoE capable interfaces are displayed. 602