D-Link DGS-3130 Emulator - Page 519
This example shows how to display a specific physical interface
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 519 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Any Configuration Mode. Command Default Level Level: 1. Usage Guideline This command displays the LLDP information of each physical interface. Example This example shows how to display a specific physical interface's LLDP configuration. Switch#show lldp interface ethernet 1/0/1 Port ID: eth1/0/1 Port ID :eth1/0/1 Admin Status :TX and RX Notification :Disabled Basic Management TLVs: Port Description :Disabled System Name :Disabled System Description :Disabled System Capabilities :Disabled Enabled Management Address: (None) IEEE 802.1 Organizationally Specific TLVs: Port VLAN ID Enabled Port_and_Protocol_VLAN_ID (None) Enabled VLAN Name (None) Enabled Protocol_Identity (None) IEEE 802.3 Organizationally Specific TLVs: :Disabled MAC/PHY Configuration/Status Link Aggregation Maximum Frame Size Energy Efficient Ethernet :Disabled :Disabled :Disabled :Disabled LLDP-MED Organizationally Specific TLVs: LLDP-MED Capabilities TLV LLDP-MED Network Policy TLV LLDP-MED Inventory TLV :Disabled :Disabled :Disabled LLDP-DCBX Organizationally Specific TLVs: LLDP-DCBX ETS Configuration TLV :Disabled LLDP-DCBX ETS Recommendation TLV :Disabled LLDP-DCBX Priority-based Flow Control Configuration TLV :Disabled Switch# 515
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/519.png)