D-Link DGS-3130 Emulator - Page 547

Parameters None. DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default By default, 802.1Q VLAN is used. Command Mode VLAN Configuration Mode. Command Default Level Level: 12. Usage Guideline Use the remote-span command in the VLAN configuration mode to specify a VLAN as an RSPAN VLAN. When a VLAN is specified as an RSPAN VLAN, the MAC address learning option on the RSPAN VLAN is disabled. Use this command on any of the intermediate switches and the destination switch involved in the RSPAN session. For any of the intermediate switches involved in a RSPAN session, the port that the monitored packets arrive on and the port that the monitored packets leave from need to be configured as tagged member ports of the RSPAN VLAN. Example This example shows how to assign VLAN 100 as the RSPAN VLAN on an intermediate switch in the RSPAN session. Interface ethernet 1/0/1 is where the monitored packets arrive on and ethernet 1/0/5 is where the monitored packets leave from. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# switchport mode trunk Switch(config-if)# switchport trunk allowed vlan 100 Switch(config-if)# exit Switch(config)# interface ethernet 1/0/5 Switch(config-if)# switchport mode trunk Switch(config-if)# switchport trunk allowed vlan 100 Switch(config-if)# exit Switch(config)# vlan 100 Switch(config-vlan)# remote-span Switch(config-vlan)# 51-8 no monitor session This command is used to delete a monitor session. no monitor session SESSION-NUMBER Parameters SESSION-NUMBER Specifies the session number of the monitor session to be deleted. The valid range is from 1 to 4. 543