D-Link DGS-3130 Emulator - Page 625

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is available for physical port interface configuration. This command is used to enable PPPoE circuit ID insertion per interface. You can use pppoe circuit-id-insert global configuration mode command to enable the PPPoE circuit insertion globally. Only when both of global and per interface state are enabled, the operational state of PPPoE circuit ID insertion is enabled on an interface. If the operational state of PPPoE circuit ID insertion is enabled on an interface, when the received PPPoE PADI/PADR packets without circuit ID TAG, the device will insert circuit ID TAG and forward the packets. If the received PPPoE PADO/PADS packets with circuit ID TAG, the packets will be forwarded after the tag is stripped out. Example The example shows how to enable PPPoE circuit ID insertion on interface eth1/0/1. switch# configure terminal switch(config)# interface eth1/0/1 switch(config-if)# pppoe circuit-id-insert The example shows how to disable PPPoE circuit ID insertion on interface eth1/0/1. switch# configure terminal switch(config)# interface eth1/0/1 switch(config-if)# no pppoe circuit-id-insert 60-3 pppoe circuit-id-insert format This command is used to configure a specific port's circuit ID. pppoe circuit-id-insert format { ip | mac | udf STRING } no pppoe circuit-id-insert format Parameters ip mac udf STRING Switch IP address will be used to encode the circuit ID option Switch VLAN1 interface MAC address will be used to encode the circuit ID option. A user defined string to be used to encode the circuit ID option. The maximum length is 32. Default By default, switch's IP address (ip) is configured. 621