D-Link DGS-3130 Emulator - Page 838

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline The surveillance packets arriving at the surveillance VLAN enabled port are marked to the COS specified by the command. The remarking of COS allows the surveillance VLAN traffic to be distinguished from data traffic in quality of service. Example This example shows how to configure the priority of the surveillance VLAN to be 7. Switch# configure terminal Switch(config)# surveillance vlan qos 7 Switch(config)# 82-6 show surveillance vlan This command is used to display the surveillance VLAN configurations. show surveillance vlan [interface [INTERFACE-ID [, | -]]] show surveillance vlan device [interface [INTERFACE-ID [, | -]]] Parameters device interface INTERFACE-ID , - Specifies to display the learned surveillance devices information (Optional) Specifies to display surveillance VLAN information of ports. (Optional) Specifies the port to be displayed. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline Use this command to display the surveillance VLAN configurations. The show surveillance vlan command is used to display the surveillance VLAN global configurations. The show surveillance vlan interface command is used to display the surveillance VLAN configurations on the interfaces. The show surveillance vlan device command is used to display the surveillance device discovered by its OUI. Example This example shows how to display the surveillance VLAN global settings. 834