D-Link DGS-3130 Emulator - Page 723

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 69-12 timers This command is used to configure the IPv6 RIP network timers. Use the no form of this command to revert to the default setting. timers UPDATE INVALID FLUSH no timers Parameters UPDATE INVALID FLUSH Specifies the update interval at which the update message is sent. The range is from 5 to 65535. Specifies the invalidate timer in seconds. The range is from 1 to 65535. Specifies the flush timer in seconds. The range is from 1 to 65535. Default The default update time: 30 seconds. The default invalid time: 180 seconds. The default flush time: 120 seconds. Command Mode Router Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to modify the IPv6 RIP protocol timers. Example This example shows how to configure the RIP timers. The Timers of update, invalid, and flush timers are set to 10, 40, and 160 respectively. Switch# configure terminal Switch(config)# ipv6 router rip Switch(config-rtr)# timers 10 40 160 Switch(config-rtr)# 69-13 debug ipv6 rip This command is used to turn on the IPv6 RIP debug function. Use the no form of this command to turn off the IPv6 RIP debug function. debug ipv6 rip no debug ipv6 rip Parameters None. 719