D-Link DGS-3130 Emulator - Page 577

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline This command is used to report the join information to the source port. The purpose is to avoid the control packets being dropped by the uplink router due to IP spoofing checks. If the replacing address is configured before forwarding the IGMP/MLD report/leave/done packet sent by the host, the source IP address in the report/leave/done packet will be replaced by this IP address. Otherwise, the source IP address will not be replaced. Example This example shows how to configure the IPv4 and IPv6 replacing source address. Switch#configure terminal Switch(config)#mvlan vlan 100 Switch(config-mvlan)#replace-source-ip ipv4 1.10.10.10 from receiver Switch(config-mvlan)#replace-source-ip ipv6 FE80:3000::3 from source Switch(config-mvlan)# 53-7 mvlan group-profile This command is used to create a group profile for the multicast VLAN feature. Use the no form of this command to remove a group profile or all group profiles. mvlan group-profile PROFILE-NAME no mvlan group-profile {PROFILE-NAME | all} Parameters PROFILE-NAME all Specifies the name of the profile. Specifies to remove all multicast VLAN profiles. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline A profile is used to define group address ranges. Multicast VLANs will check if the group address in the IGMP/MLD packet matches the range of addresses defined in this profile. Example This example shows how to create a profile named "mv_profile1". Switch#configure terminal Switch(config)#mvlan group-profile mv_profile1 Switch(config-mvlan-profile)# 573