D-Link DGS-3130 Emulator - Page 816
spanning-tree forward-bpdu, 27 spanning-tree nni-bpdu-address
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 816 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to configure the transmit hold count value to 5. Switch# configure terminal Switch(config)# spanning-tree tx-hold-count 5 Switch(config)# 78-26 spanning-tree forward-bpdu This command is used to enable the forwarding of the spanning tree BPDU. Use the no form of this command to disable the forwarding of the spanning tree BPDU. spanning-tree forward-bpdu no spanning-tree forward-bpdu Parameters None. Default By default, this option is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline If enabled, the received STP BPDU will be forwarded to all VLAN member ports in the untagged form. The command does not take effect if the Layer 2 protocol tunnel is enabled for STP. Example This example shows how to enable the forwarding of STP BPDUs. Switch# configure terminal Switch(config)# interface ethernet 1/0/2 Switch(config-if)# spanning-tree forward-bpdu Switch(config-if)# 78-27 spanning-tree nni-bpdu-address This command is used to configure the destination address of the STP BPDU in the service provider site. Use the no form of this command to revert to the default setting. spanning-tree nni-bpdu-address {dot1d | dot1ad} no spanning-tree nni-bpdu-address 812