D-Link DGS-3130 Emulator - Page 769

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 76-4 snmp-server engineID local This command is used to specify the SNMP engine ID on the local device. Use the no form of this command to revert to the default setting. snmp-server engineID local ENGINEID-STRING no snmp-server engineID local Parameters ENGINEID-STRING Specifies the engine ID string of a maximum of 24 characters. Default A default SNMP engine ID is automatically generated. Command Mode Global Configuration Mode. Command Default Level Level: 15. Usage Guideline An SNMP engine ID is not displayed or stored in the running configuration. The SNMP engine ID is a unique string to identify the device. A string is generated by default. If you configure a string less than 24 characters, it will be filled with trailing zeros up to 24 characters. Example This example shows how to configure the SNMP engine ID to 332200000000000000000000. Switch# configure terminal Switch(config)# snmp-server engineID local 3322 Switch(config)# 76-5 snmp-server group This command is used to configure an SNMP group. Use the no form of this command to remove a SNMP group or remove a group from using a specific security model. snmp-server group GROUP-NAME {v1 | v2c | v3 {auth | noauth | priv}} [read READ-VIEW] [write WRITEVIEW] [notify NOTIFY-VIEW] [access IP-ACL-NAME] no snmp-server group GROUP-NAME {v1 | v2c | v3 {auth | noauth | priv}} Parameters GROUP-NAME v1 v2c v3 auth Specifies the group name of a maximum of 32 characters. The syntax is general string that does not allow space. Specifies that the group user can use the SNMPv1 security model. Specifies that the group user can use the SNMPv2c security model. Specifies that the group user can use the SNMPv3 security model. Specifies to authenticate the packet but not encrypt it. 765