D-Link DGS-3130 Emulator - Page 126

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to enable IP ARP elevation. Switch# configure terminal Switch(config)# ip arp elevation Switch(config)# 9-8 ip mtu This command is used to set the MTU value. Use the no form of this command to revert to the default setting. ip mtu BYTES no ip mtu Parameters BYTES Specifies to set the IP MTU value. The range is 512 to 16383 bytes. Default By default, the MTU value is 1500 bytes. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Some routing protocols, such as OSPF, will advertise this setting in the routing updates. Example This example shows how to set the IP MTU value as 6000 bytes for VLAN 4. Switch# configure terminal Switch(config)# interface vlan 4 Switch(config-if) ip mtu 6000 Switch(config-if)# 9-9 show arp This command is used to display the ARP cache. show arp [ARP-TYPE] [ip-address [MASK]] [INTERFACE-ID] [HARDWARE-ADDRESS] Parameters ARP-TYPE (Optional) Specifies the ARP type. dynamic - Specifies to display only dynamic ARP entries. static -Specifies to display only static ARP entries. 122