D-Link DGS-3130 Emulator - Page 604
poe usage-threshold, snmp-server enable traps poe
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 604 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch(config)# interface eth3/0/1 Switch(config-if)# poe power-inline auto 5000 This example shows how to disable PD detection and not to power a PoE port on port eth3/0/1. Switch(config)# interface eth3/0/1 Switch(config-if)# poe power-inline never This example shows how to combine a time-range profile "day_time" with PoE port on port eth3/0/1. Switch(config)# interface eth3/0/1 Switch(config-if)# poe power-inline auto time-range day_time 56-6 poe usage-threshold This command is used to configure the utilization threshold to initiate a notification. Use the no form of this command to restore the default setting. poe unit UNIT-ID usage-threshold PERCENTAGE no poe unit UNIT-ID usage-threshold Parameters PERCENTAGE UNIT-ID Specifies a usage threshold to generate a notification. The valid range is1 to 99. The unit is percentage (Optional) Specify the unit to display. Default By default, this value is set as 99. Command Mode Global configuration mode. Command Default Level Level: 12. Usage Guideline When the usage threshold is configured, if the utilization of the PSE exceeds the configured notification threshold, then the "pethMainPowerUsageOnNotification" trap will be initiated. Once the percentage decreases and become lower than the notification threshold, then the "pethMainPowerUsageOffNotification" trap is initiated to indicate this situation. Example This example shows how to configure the usage notification threshold to 50%. Switch(config)# poe unit 1 usage-threshold 50 Switch(config)# 56-7 snmp-server enable traps poe This command is used to enable sending of power over ethernet notifications. Use the no form of the command to disable sending power over Ethernet notifications. 600