D-Link DGS-3130 Emulator - Page 374
ring_type
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 374 highlights
Parameters RING-ID DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies the identifier of a physical ring. The valid range is from 1 to 239. Default None. Command Mode ERPS Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to configure the ring ID of a physical ring. A different ring ID, in ERPSv2, must be assigned to each physical ring. This command is used in ERPSv2 only. Example This example shows how to configure the ring value 2 of the G8032 ring "ring2". Switch#configure terminal Switch(config)#ethernet ring g8032 ring2 Switch(config-erps-ring)#ring_id 2 Switch(config-erps-ring)# 33-20 ring_type This command is used to specify the ring type of a physical ring. Use the no form of this command to revert to the default setting. ring_type {major-ring | sub-ring} no ring_type Parameters major-ring sub-ring Specifies an ERPS ring as a major-ring. Specifies an ERPS ring as a sub-ring. Default By default, the ERPS ring is a major-ring. Command Mode ERPS Configuration Mode. Command Default Level Level: 12. 370