D-Link DGS-3130 Emulator - Page 339
Ethernet OAM Commands
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 339 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 32. Ethernet OAM Commands 32-1 ethernet oam This command is used to enable the Ethernet OAM function on the specified port. Use the no form of this command to disable the function. ethernet oam no ethernet oam Parameters None. Default By default, the Ethernet OAM function is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline After enabling this function on the interface, the interface will start OAM discovery. If the OAM mode of this interface is active, it initiates the discovery. Otherwise, it reacts to the discovery received from the peer. Example This example shows how to enable Ethernet OAM on ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# ethernet oam Switch(config-if)# 32-2 ethernet oam mode This command is used to configure the Ethernet OAM mode on the specified port. Use the no form of this command to revert to the default setting. ethernet oam mode {active | passive} no ethernet oam mode Parameters active passive Specifies that the port's Ethernet OAM mode is active. Specifies that the port's Ethernet OAM mode is passive. 335