D-Link DGS-3130 Emulator - Page 710
router rip
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 710 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide The metric of the redistributed route from other protocols to RIP process will be 1 if the metric option is specified as 0. If the default metric is not specified, then the original metric from the redistributed protocol will be transparently carried through. If a route map is configured but the route map doesn't exist, it means all routes are not permitted. If a route map sequence has no match entry defined, then all routes will match this sequence. Example This example shows how to configure that the specified OSPF process routes will be redistributed into an RIP domain. The OSP-derived metric will be remapped to 10. Switch# configure terminal Switch(config)# router rip Switch(config-router)# redistribute ospf Switch(config-router)# metric 10 68-12 router rip This command is used to configure the RIP routing process. Use the no form of this command to disable the RIP routing process. router rip no router rip Parameters None. Default By default, this option is disabled. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to enter the Router Configuration Mode of the RIP protocol and enable the RIP function. The no command will remove the configuration in the RIP router mode and disable RIP process. Example This example shows how to begin the RIP routing process. Switch# configure terminal Switch(config)# router rip Switch(config-router)# 706