D-Link DGS-3130 Emulator - Page 616
port-security limit
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 616 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to disable the ageing or set the ageing time for auto-learned dynamic secured entries. In order for the inactivity setting to take effect, the FDB table ageing function must be enabled. Example This example shows how to apply the aging time for automatically learned secure MAC addresses for ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# switchport port-security aging 1 Switch(config-if)# This example shows how to configure the port security aging time type for ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# switchport port-security aging type inactivity Switch(config-if)# 58-6 port-security limit This command is used to configure the maximum secure MAC address number on the system or on the specified VLAN. Use the no form of this command to revert to the default setting. port-security limit {global | vlan VLAN-ID [, | -]} VALUE no port-security limit {global | vlan VLAN-ID [, | -]} Parameters global vlan VLAN-ID , - VALUE Specifies that this setting will be applied to the system. Specifies the VLAN ID that will be used. (Optional) Specifies a series of VLANs, or separate a range of VLANs from a previous range. No space is allowed before and after the comma. (Optional) Specifies a range of VLANs. No space is allowed before and after the hyphen. Specifies the maximum number of port security entries that can be learned on the system or specified VLAN. The range is from 1 to 64. If the setting is smaller than the number of current learned entries, the command will be rejected. Default By default, this option is no limit. 612