D-Link DGS-3130 Emulator - Page 638

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 62-6 ipv6 route This command is used to create an IPv6 static route entry. Use the no command to remove an IPv6 static route entry. ipv6 route {default | NETWORK-PREFIX/PREFIX-LENGTH} {[INTERFACE-ID] NEXT-HOP-ADDRESS [{primary | backup}] [DISTANCE]} no ipv6 route {default | NETWORK-PREFIX/PREFIX-LENGTH} {[INTERFACE-ID] NEXT-HOP-ADDRESS} Parameters default NETWORKPREFIX/PREFIX-LENGTH INTERFACE-ID NEXT-HOP-ADDRESS primary backup DISTANCE Specifies to add or delete a default route. Specifies the network prefix and the prefix length of the static route. (Optional) Specifies the forwarding interface for routing the packet. Specifies the IPv6 address of the next hop to reach the destination network. If the address is a link-local address, then the interface ID also need to be specified. (Optional) Specifies the route as the primary route to the destination. (Optional) Specifies the route as the backup route to the destination. (Optional) Specifies the administrative distance of the static route. The range of distance is 1 to 254. The lower value represents better route. If not specified, the default administrative distance for a static route is 1. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Floating state route is supported. This means that there could have two routes with the same destination network address but different next hop. If none of the primary or backup parameter is specified, the static route will be automatically determined to be a primary route or a backup route. Primary route is preferable, and is always be used for forwarding when it is active. When the primary route is down, the backup route will be used. Example This example shows how to create a static route destined for the network where proxy server resides. Switch# configure terminal Switch(config)# ipv6 route 2001:0101::/32 vlan 1 fe80::0000:00ff:1111:2233 Switch(config)# 62-7 ip route ecmp advance-control mode This command is used to enlarge or reduce the number of ECMP or multipath route. Use the no form of this command to revert to the default setting. 634