D-Link DGS-3130 Emulator - Page 618
Power Saving Commands
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 618 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 59. Power Saving Commands 59-1 dim led This command is used to disable the port LED function. Use the no form of this command to restore the LED function. dim led no dim led Parameters None. Default By default, this option is enabled. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to turn off the port LED function. Use the no form of the command to restore the LED function. When the port LED function is disabled, LEDs used to illustrate port status are all turned off to save power. Example This example shows how to disable the port LED function. Switch# configure terminal Switch(config)# dim led Switch(config)# 59-2 power-saving This command is used to enable individual power saving functions. Use the no form of this command to disable these functions. power-saving {link-detection | length-detection | port-shutdown | dim-led | hibernation} no power-saving {link-detection | length-detection | port-shutdown | dim-led | hibernation} Parameters link-detection length-detection dim-led port-shutdown Specifies that power saving will be applied by link status. Specifies that power saving will be applied by cable length detection. Specifies that power saving will be applied by scheduled dimming LEDs. Specifies that power saving will be applied by scheduled port shutdown. 614
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/618.png)