D-Link DGS-3130 Emulator - Page 907
vrrp ip
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 907 highlights
Parameters STRING DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies the plain text authentication password. This string can be up to 8 characters long. Default By default, no authentication is used. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to enable VRRP authentication on an interface. The authentication is applied to all virtual routers on this interface. The devices in the same VRRP group must have the same authentication password. Example This example shows how to configure one interface's VRRP authentication: Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# vrrp authentication test Switch(config-if)# 91-3 vrrp ip This command is used to create a VRRP group on an interface. Use the no form of this command to remove a VRRP group. vrrp VRID ip IP-ADDRESS no vrrp VRID Parameters VRID IP-ADDRESS Specifies the virtual router identifier that identifies the VRRP group. The valid range is from 1 to 255. Specifies the IP address for the created virtual router group. Default None. Command Mode Interface Configuration Mode. Command Default Level Level: 12. 903
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/907.png)