D-Link DGS-3130 Emulator - Page 610
show ip policy
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 610 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# route-map pbr-map permit 1 Switch(config-route-map)# match ip address pbr-acl Switch(config-route-map)# set ip next-hop 20.1.1.254 Switch(config-route-map)# exit Switch(config)# interface vlan 100 Switch(config-if)# ip policy route-map pbr-map Switch(config-if)# 57-2 show ip policy This command is used to display the route map used for policy-based routing. show ip policy Parameters None. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline Use the command to display the policy-based routing information configured on interfaces. Example This example shows how to display policy-based information configured on interfaces. Switch#show ip policy Interface Route Map vlan 1 pbr-map1 vlan 2 pbr-map2 vlan 100 pbr-map3 Total Entries: 3 Switch# 606
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/610.png)