D-Link DGS-3130 Emulator - Page 878

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 89. Virtual LAN (VLAN) Commands 89-1 acceptable-frame This command is used to set the acceptable types of frames by a port. Use the no form of this command to revert to the default setting. acceptable-frame {tagged-only | untagged-only | admit-all} no acceptable-frame Parameters tagged-only untagged-only admit-all Specifies that only tagged frames are admitted. Specifies that only untagged frames are admitted. Specifies that all frames are admitted. Default For the access VLAN mode, the default option is untagged-only. For the other VLAN mode, the default option is admit-all. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to set the acceptable types of frames by a port. Example This example shows how to set the acceptable frame type to tagged-only for port Ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# acceptable-frame tagged-only Switch(config-if)# 89-2 ingress-checking This command is used to enable ingress checking for frames received by a port. Use the no form of this command to disable the ingress check. ingress-checking no ingress-checking Parameters None. 874