D-Link DGS-3130 Emulator - Page 851
ip tftp source-interface
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 851 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# copy tftp: //10.1.1.254/image.had flash: image.had Address of remote host [10.1.1.254]? Source filename [image.had]? Destination filename [image.had]? Accessing tftp://10.1.1.254/image.had... Transmission start... Transmission finished, file length 8315060 bytes. Transmission to slave start Done. Transmission to slave finished, file length 8315060 bytes. Please wait, programming flash Done. Wait slave programming flash complete... Done. Switch# 84-7 ip tftp source-interface This command is used to specify the interface whose IP address will be used as the source address for initiating TFTP packets. Use the no form of this command to revert to the default setting. ip tftp source-interface INTERFACE-ID no ip tftp source-interface Parameters INTERFACE-ID Specifies the interface whose IP address will be used as the source address for initiating TFTP packets. Default The IP address of the closest interface will be used. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use the command to specify the interface whose IP address will be used as the source address for initiating TFTP packets. To load the software from the out of band management port, specify the interface ID for the out of band management port. Only Loopback, MGMT and VLAN interfaces are supported in this command. Example This example shows how to download software from the out of band management port. Switch# configure terminal Switch(config)# ip tftp source-interface mgmt0 Switch(config)# 847