D-Link DGS-3130 Emulator - Page 842

Parameters auto normal cross DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies to set the port interface's MDIX state to the auto-MDIX mode. Specifies to force the port interface's MDIX state to the normal mode. Specifies to force the port interface's MDIX state to the cross mode. Default By default, this option is set as auto. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command cannot be applied to a port when the medium of the port interface is fiber. Example This example shows how to configure the MDIX state of interface ethernet 1/0/1 to auto: Switch# configure terminal Switch(config)#interface ethernet 1/0/1 Switch(config-if)#mdix auto Switch(config-if)# 83-4 speed This command is used to configure the physical port interface's speed settings. Use the no form of this command to revert to the default setting. NOTE: 10G does not support speed configurations of 10Mbps and 100Mbps. speed {10 | 100 | 1000 [master | slave] | 10giga [master | slave] | auto [SPEED-LIST]} [rj45 | sfp] no speed [rj45 | sfp] Parameters 10 100 1000 master | slave 10giga Specifies to force the speed to 10Mbps. Specifies to force the speed to 100Mbps. Specifies that for copper ports, it forces the speed to 1000Mbps and the user must manually set that the port operates as master or slave. Specifies that for fiber ports (1000BASE-SX/LX), the port will disable the autonegotiation. Specifies the port operates as master or slave timing. This parameter is only applicable to 1000BASE-T connections. Specifies to force the speed to 10Gbps. 838