D-Link DGS-3130 Emulator - Page 504

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# lldp dot1-tlv-select port-vlan Switch(config-if)# This example shows how to enable advertising Port and Protocol VLAN ID TLV. The advertised VLAN includes 1 to 3. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# lldp dot1-tlv-select protocol-vlan 1-3 Switch(config-if)# This example shows how to enable the VLAN Name TLV advertisement from vlan1 to vlan3. Switch# configure terminal Switch(config)#interface ethernet 1/0/1 Switch(config-if)#lldp dot1-tlv-select vlan-name 1-3 Switch(config-if)# This example shows how to enable the LACP Protocol Identity TLV advertisement. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# lldp dot1-tlv-select protocol-identify lacp Switch(config-if)# 48-4 lldp dot3-tlv-select This command is used to specify which optional type-length-value settings (TLVs) in the IEEE 802.3 organizationally specific TLV set will be encapsulated in LLDPDUs and sent to neighbor devices. Use the no form of this command to disable the transmission of the TLVs. lldp dot3-tlv-select [mac-phy-cfg | link-aggregation | max-frame-size] no lldp dot3-tlv-select [mac-phy-cfg | link-aggregation | max-frame-size] Parameters mac-phy-cfg link-aggregation max-frame-size (Optional) Specifies the MAC/PHY configuration/status TLV to send. The MAC/PHY configuration/status TLV is an optional TLV that identifies (1) the duplex and bit-rate capability of the sending IEEE 802.3 LAN node, and (2) the current duplex and bit-rate settings of the sending IEEE 802.3 LAN node. (Optional) Specifies the link aggregation TLV to send. The link aggregation TLV contains the following information. Whether the link is capable of being aggregated, whether the link is currently in an aggregation, and the aggregated port channel ID of the port. If the port is not aggregated, then the ID is 0. (Optional) Specifies the maximum frame size TLV to send. The maximum frame size TLV indicates the maximum frame size capability of the implemented MAC and PHY. Default No IEEE 802.3 organizationally specific TLV is selected. 500