D-Link DGS-3130 Emulator - Page 806
spanning-tree timers
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 806 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command in the global configuration mode to enable the global spanning-tree function. Example This example shows how to enable the spanning-tree function. Switch# configure terminal Switch(config)# spanning-tree global state enable Switch(config)# 78-13 spanning-tree (timers) This command is used to configure the Spanning Tree timer value. Use the no form of this command to revert to the default settings. spanning-tree {hello-time SECONDS | forward-time SECONDS | max-age SECONDS} no spanning-tree {hello-time | forward-time | max-age} Parameters hello-time SECONDS forward-time SECONDS max-age SECONDS Specifies the interval that a designated port will wait between the periodic transmissions of each configuration message. The range is from 1 to 2 seconds. Specifies the forward delay time used by STP to transition from the listening to the learning states and learning to forwarding states. The range is from 4 to 30 seconds. Specifies the maximum message age of BPDU. The range is from 6 to 40 seconds. Default The default value of the hello-time is 2 seconds. The default value of the forward-time is 15 seconds. The default value of the max-age is 20 seconds. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to configure the Spanning Tree timer value. 802