D-Link DGS-3130 Emulator - Page 348
ethernet oam received-remote-loopback
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 348 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Usage Guideline The command is used to request the remote peer to enter or exit the Ethernet OAM remote loopback mode. Use the ethernet oam remote-loopback start command to request the remote peer to enter the Ethernet OAM remote loopback mode. Use the ethernet oam remote-loopback stop command to request the remote peer to exit the Ethernet OAM remote loopback mode. If the remote peer is configured to ignore the remote loopback request, then the remote peer will not enter or exit the remote loopback mode upon receiving the request. To start the remote peer to enter the remote loopback mode, administrators must ensure that the local client is in the active mode and the OAM connection is established. If the local client is already in the remote loopback mode, then this command cannot be applied. Example This example shows how to start the Ethernet OAM remote loopback on ethernet 1/0/1. Switch# ethernet oam remote-loopback start interface ethernet 1/0/1 Switch# 32-10 ethernet oam received-remote-loopback This command is used to configure the behavior of the received remote loopback requirement from the peer on the specified port. Use the no form of this command to revert to the default setting. ethernet oam received-remote-loopback {process | ignore} Parameters process ignore Specifies to react to remote loopback requirements from a peer. Specifies not to react to remote loopback requirements from a peer. Default The Ethernet OAM ignores remote loopback requirement by default. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is used to configure the client to process or to ignore the received Ethernet OAM remote loopback command. In the remote loopback mode, all user traffic will not be processed. Ignoring the received remote loopback command will prevent the port from entering the remote loopback mode. Example This example shows how to enable processing the Ethernet OAM remote loopback command on ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# ethernet oam received-remote-loopback process Switch(config-if)# 344