D-Link DGS-3130 Emulator - Page 46
expert access-list
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline If expert access group is already configured on the interface, the command applied later will overwrite the previous setting. Only one access-list of the same type can be applied to the same interface; but access-lists of different types can be applied to the same interface. Example This example shows how to apply an expert ACL to an interface. The purpose is to apply the ACL exp_acl on the ethernet 1/0/2 to filter the incoming packets. Switch# configure terminal Switch(config)# interface ethernet 1/0/2 Switch(config-if)# expert access-group exp_acl in Switch(config-if)# end Switch# show access-group interface ethernet 1/0/2 eth1/0/2: Inbound expert access-list : exp_acl(ID: 8999) Switch# 4-4 expert access-list This command is used to create or modify an extended expert ACL. This command will enter into the extended expert access-list configuration mode Use the no form of this command to remove an extended expert access-list. expert access-list extended NAME [NUMBER] no expert access-list extended {NAME | NUMBER} Parameters NAME NUMBER Specifies the name of the extended expert access list to be configured. The name can be up to 32 characters. Specifies the ID number of expert access list. For extended expert access lists, the value is from 8000 to 9999. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline The name must be unique among all access lists. The characters used in the name are case sensitive. The biggest unused number in the range of the expert access list numbers will be assigned automatically. 42