D-Link DGS-3130 Emulator - Page 862
logging source-interface, show logging
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 862 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Example This example shows how to enable the logging of system messages with a severity higher than warnings to email recipients. Switch# configure terminal Switch(config)# logging smtp severity warnings Switch(config)# 85-8 logging source-interface This command is used to specify the interface whose IP address will be used as the source address for sending the SYSLOG packet. Use the no form of this command to revert to the default setting. logging source-interface INTERFACE-ID no logging source-interface Parameters INTERFACE-ID Specifies the interface whose IP address will be used as the source address of the SYSLOG packet. Default By default, the IP address of the closest interface will be used. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this command to specify the interface whose IP address will be used as the source address of the SYSLOG packet. Only Loopback, MGMT and VLAN interfaces are supported in this command. Example This example shows how to configure VLAN 100 as the source interface for SYSLOG packets. Switch# configure terminal Switch(config)# logging source-interface vlan 100 Switch(config)# 85-9 show logging This command is used to display the system messages logged in the local message buffer. 858