D-Link DGS-3130 Emulator - Page 654

Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide dscp DSCP-LIST green yellow red Specifies the list of DSCP code point to be mapped to a color. The range is from 0 to 63. The multiple DSCP values in the list can be in the form separated by commas or a range list. Specifies to be mapped to green. Specifies to be mapped to yellow. Specifies to be mapped to red. Default There is no mapping. All DSCP code points are mapped to green color. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to define the DSCP to color map for the mapping of a packet's initial color. Example This example shows how to define DSCP 61 to 63 as the yellow color and any other IP packet is initialized with the green color at Ethernet 1/0/1. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# mls qos map dscp-color 61-63 to yellow Switch(config-if)# 63-9 mls qos map dscp-cos This command is used to define a DSCP-to-CoS map. Use the no form of this command to revert to the default setting. mls qos map dscp-cos DSCP-LIST to COS-VALUE no mls qos map dscp-cos DSCP-LIST Parameters dscp-cos DSCP-LIST to COST-VALUE DSCP-LIST Specifies the list of DSCP code points to be mapped to a CoS value. The range is from 0 to 63. The series of DSCPs can be separated by commas (,) or hyphens (-) with no spaces or hyphens before and after. Specifies the range of DSCP values. Default CoS Value: 0 DSCP Value: 0-7 1 8-15 2 3 4 5 6 7 16-23 24-31 32-39 40-47 48-55 56-63 650